吉林附近有没有服务

 

Service hotline:
eighteen billion six hundred and thirty-seven million three hundred and two thousand and ninety-nine
 
 

Latest cases

What is the function of double axis Shredder?

Features of double shaft shredder: compared with other crushers, the features of the shredder are low speed of cutter shaft, low noise and low energy consumption. The suitable materials of the double axis shredder are as follows: 1. Various hollow containers: plastic beverage cans, plastic barrels, iron drums, packing boxes, etc

Click to see the details

How to save production cost of users by shredder

High manganese steel lining plate is used for shredder equipment lining plate, which greatly improves wear resistance and service life is 6-8 months, which greatly saves production cost of users. After being processed and crushed by shredder, these scrap iron sheets can be sent to steelmaking plant for smelting again to make new steel

Click to see the details

Current position: home page  >  News Center

Blade making technology of wood shredder

  Wood shredder Manufacturing technology of blade

 
1. Check the weld strength: grind the back edge of a shredder with green silicon carbide grinding wheel, and check the thickness of solder layer. The thickness is required to be 0. Below 15 mm. There should be no air hole and lack of solder on the bottom surface of tool tip support, and the weld with incomplete solder should not be more than 10% of the total weld length. If there are air holes, the blade will crack when tearing.
 
2. Check the position of the shredder blade in the slot: if the blade dislocation and droop exceed the skill requirements, rewelding should be carried out.
 
3. Check the welding strength: knock the blade with medium strength with wooden hammer or copper hammer, or knock the knife bar with I hammer with strong force. If the blade does not fall from the slot, it is qualified. To check the welding strength of the blade, it is not necessary to check them one by one, but also select the method of checking.
 
4. Check the evenness of the shredder blade: if there are obvious pits on the blade, it is clarified that the blade is overheated and deformed, and a new blade shall be burned down and welded again.
 
5. Check the crack: if the blade of shredder is cracked after being cleaned with kerosene. The kerosene penetrates into the cracks and appears black lines, which can be detected by naked eyes. 10-40 times magnifying glass can also be used for investigation.

About us
Company profile
corporate culture
contact us
News Center
Company news
Industry trends
technical knowledge
Product exhibition hall
Metal crusher
Shredder
Baler
Successful cases
Engineering cases
Service support
Sales network
Service system